How to match the telescopic arm and the single arm with the Skip Bin?

2022-12-01 00:21:47

Because all hook-arm trucks must be used in conjunction with the box, special attention is paid to the Skip Bin. If the customer distributes the car and the box at the same time, then we can according to the customer's requirements, such as how many cubic meters of garbage to pull at a time, the heavy construction waste box can be made smaller, and the household garbage can be made larger, but if you want to pull it.

When distributing boxes, the telescopic sleeve arm can be equipped with any size box (the extension and contraction of the arm can be controlled), while the single arm has strict requirements on the length of the box (the length of the box is determined according to the wheelbase, and the box can only be at a height Whether it is manual or loader loading, it is difficult to operate if the box is too high). When the amount is small and light, it can be selected.

Construction waste is relatively heavy and must be equipped with rear outriggers, because too much waste tends to tilt its head, which is too unsafe. If the garbage on the rear outriggers is too heavy, the hook-arm truck cannot work normally, not only cannot hook up, but also tilts the front of the truck. The outriggers of the jib truck support the ground, and even the most important garbage can be pulled up normally. The front of the car will not be tilted. Therefore, we recommend installing rear outriggers in customer use.